Production KNURLING: We take pride in how detailed our knurls turn out.

Production

We developed our own tooling, insert and tool holder to perform  this Deep hole TREEPANING. This tool was designed to not only meet the need of this part but, the needs of  all the family parts.

All parts seen here are produced from ALUMINUM in one operation.

 

All parts seen here are produced from Copper or Brass. Set up time between family of parts is minimal.

 

These small parts are produced in one operation, inside diameter, outside diameter, overall length, and flange tolerance is +.000 –.001 inch. In quantities of 1000 at a time these parts need to be 100% burr free, this is also preformed during manufacturing.

Family run parts, produced in LEFT and RIGHT hand, 3 different size grooves in front, and with / without offset face taped hole.

 

All parts here are produced from many types of 

 

Cold Roll Steel, Stainless Steel, Tool Steel

Live tooling  results in cost savings for the customer, NO second operation is needed.

 

Even the lower parts are produced in one operation, then heat treated and tumbled all performed in house.

Large part production, We feed up too 2.750 Diameter solid stock through spindle. Larger then 2.750 is loaded directly into the chuck .

With our innovative way of producing, parts such as these are manufactured from start to finish under 2 minutes, without sacrificing repeatability  or quality.